Shutters installation methods:
Windows Factory VIDAWO reserves the right to make changes in the following models.
A-02
The shutter is mounted to an additional 70x70mm spacer frame. Special hinges allow lining shutters from the window opening on the wall up to a distance of 200mm. The wind lock is hinged so you can unlock it without going outside.
A-03
The modified A-02 mounting method is supplemented with an additional extension that allows the mosquito net to be installed. The solution is mainly used in Greece.
B-01
A shutter mounted directly on the wall with wall plugs or chemical plugs. The hinges and brackets are adjustable, thanks to which you can easily adjust the shutters after assembly. The cutter around the shutter allows you to compensate for the inaccuracy of the opening, which is especially useful when renovating old buildings.
C-02
The shutter is mounted on an additional 20x80mm wooden band. Hinges and brackets are not adjustable because this way is very simple and accurate in assembly. In unusual cases, it is also possible to use fully adjustable fittings.
E-01
Z-01
A shutter mounted directly on the wall with wall plugs or chemical plugs. The hinges and brackets are adjustable, thanks to which you can easily adjust the shutters after assembly. The shutter does not have any rabbet around and is completely mounted outside the wall, thanks to which it can compensate for large hole inaccuracies, which is especially useful when renovating old buildings.
Z-02
A shutter mounted directly on the wall with wall plugs or chemical plugs. The hinges have no regulation, which means that the assembly must be done very accurately and the shutters often have to be cut in place to the existing holes. A method often used in France.
